Disposable Dust Mask Earpad Ultrasonic Boiling

Machine:

- High Speed: 64 pcs. Single Sided 32 Pieces Double Sided

Bonding

- Automatic Packing of Finished Products into Parcels

- Fully Turkish and English touch screen control

- Ultrasonic welding method bonding

- 4 axis SERVO MOTOR

- Very low air consumption thanks to Servo Motors.

- Low Electricity Consumption Thanks to Smart Energy Control

- Adjusting the earloop size on the touch screen

- High strength and quality with Robust structure

- Zero malfunction with high quality pneumatic and electronic

  equipment

- High quality Ultrasonic Welding with touch screen control

  Max. 2400w capacity - Nominal ~ 200w.

- Machine dimensions: 1000mm (L) × 500mm (W) × 1500mm (H)

- Machine weight is less than 150 kg.

- Working power: 220VAC ± 5%, 50Hz, rated power about 750w

- Compressed air: ~ 100L / min. - 0.5-0.7mpa with flow rate

- Working environment: Temperature 10-35 ℃,

  humidity 5-35% HR -

- Nominal Efficiency: 30 pcs / min.

- Qualified equipment production rate: 99% (incoming materials

  does not meet requirements and employees are not working

  properly except occasions)

- Equipment failure rate risk: 1% (caused by material

  means malfunction)

​

 

----------------------

Recommended Disposable mask material list:

A. SS non woven dark - for outer layer

1. Material weight 25 g / m2

2. Material width 200 mm

3. Cutting length of each piece: 175mm

4. Single gram weight 0.875g Note: green, blue, black, etc.

 

White melt blown non-woven fabric filter layer

1. Weight of material: 22G / m2

2.Material width 180mm

3. Cutting length of each piece: 175mm

4.Single gram weight 0.693g

Note: 90%, 95%, 99.99% of the filter index can be selected according to the production requirements of the enterprise, and 175 mm width can also be used.

 

C.SS non-woven light or white - for inner layer

1. Material weight 25 g / m2

2.Material width 210mm

3. Cutting length of each piece: 175mm

4. One piece weight 0.91875g Note: 20g can be used, but the overall mask is soft.

 

D. nose bridge

1. Cutting length of each piece: 100mm

Note: made of plastic or steel. It is recommended to use plastic with a very strong steel wire.

 

Elastic ear band

1. 1. Cutting length of each piece: 300mm

Note: one side 150mm * 2 sides = 300mm

 

Primarily, it is the mask used as the management of medical products such as "medical protective mask", "disposable general medical mask", "medical surgical mask".

Currently, three types of medical masks listed below are mainly used.

For the production of such products, it is necessary to apply for "medical device product registration certificate" and "medical device production license" from the equipment department of the provincial food and drug administration.

- Type 1 - For medical use, it is necessary to have a 100000 class or higher clean room, microbiological testing, relevant physical and chemical testing capability.

- Type 2 Protection mask (special protection equipment) should apply to the Provincial Technical Supervision Office for the production license of industrial products and apply to the State Administration for occupational safety for "safety mark of special labor protection" certification. "(LA certificate).

Type 3 is a relatively simple daily protective mask. Without any license, the product can be sent to a qualified third-party testing organization for inspection according to the relevant standards, and a qualified test report can be obtained and then released.

Note: Jet Robotics does not assume any responsibility for the currency and validity of the information provided here. For the most up-to-date and accurate information, contact the required authorities determined by the State.